Veteran-Owned & Operated Fully Mobile — St. Augustine, Ponte Vedra, Jacksonville, Palm Coast & Anywhere in Florida
Open 8:00 AM–6:00 PM, 7 Days seacoastdetail@gmail.com
Home All 32 Marine Services
Detailing, Fiberglass & Hull
Mechanical, Steering & Yard
Power, Batteries & Systems
Service Areas (Mobile FL)
About Seacoast FAQ Contact & Quote
Call (904) 815-8421 Text Boat Photos for a Quote
Deck Hardware & Ground Tackle

Marine Windlass & Anchor System Repair & Installation

Do not wrestle a heavy anchor by hand in tidal current. We install, rebuild, and wire marine anchor windlasses, reversing solenoids, heavy-gauge bow runs, foot switches, and bow rollers—mobile across Florida.

Express sportfishing cruiser docked cleanly at marina slip
Bow deck hardware, windlass controls, and ground tackle serviced for offshore cruisers.

Reliable Ground Tackle & Heavy-Duty Bow Wiring for Tidal Florida Waters

St. Augustine Inlet, Matanzas River, and the St. Johns River run fast tidal currents where holding ground and fast anchor retrieval matter. When a windlass clicks without turning, stalls under load, leaks gear oil into the anchor locker, or trips its breaker halfway up, anchoring turns stressful fast.

Windlasses pull massive DC amperage over some of the longest wire runs on a boat—from aft batteries all the way to the bow pulpit. Undersized cables, corroded anchor-locker splices, seized gypsy clutches, and moisture-damaged foot switches are the most frequent failure points we fix.

Seacoast Detailing & Marine Services repairs, replaces, and installs vertical and horizontal marine windlasses, bow rollers, chain stoppers, and helm/foot controls across Northeast Florida and anywhere in Florida.

Windlass & Ground Tackle Services

Windlass Troubleshooting & Gearbox Service

Diagnosing motor draw, corroded brushes, stripped gears, seized clutches, and leaking seals on vertical and horizontal windlasses.

New Windlass & Bow Pulpit Installations

Mounting new windlasses with structural backing plates, hawse pipes, chain stoppers, and bow rollers matched to your hull.

Heavy-Gauge Bow Wiring & Breakers

Running properly sized tinned marine cable from battery banks to bow lockers with dedicated thermal breakers.

Reversing Solenoids, Helm Switches & Remotes

Replacing pitted solenoids, water-damaged deck foot switches, helm rockers, and wireless handheld windlass remotes.

Chain-to-Rope Rode & Gypsy Matching

Checking chain size/pitch against gypsy pockets, replacing worn rode/swivels, and marking anchor chain lengths.

Anchor Locker Fiberglass & Drainage Work

Glassing old deck holes when swapping windlass footprints and clearing blocked anchor-locker overboard drains.

Serving Cruisers, Center Consoles & Yachts From Jacksonville to Daytona

Saltwater spray inside bow anchor lockers corrodes unprotected butt connectors and deck foot switches far faster than cabin electronics. We seal every bow connection with adhesive heat shrink, mount solenoids in dry protected spaces, and load-test retrieval before signing off.

If you are upgrading windlass wiring or installing a dedicated bow battery/thruster bank, pair this with our Marine Electrical or Bow & Stern Thruster service. Call (904) 815-8421.

Veteran-Owned, One-Call Marine Care — Mobile Anywhere in Florida

Need multiple trades knocked out in one visit? Pair this service with fiberglass & gelcoat restoration, engine service, 12V marine electrical, Garmin installs, or Monthly Care Plans—or schedule during your haul-out at Camachee Yacht Yard in St. Augustine or the Florida boatyard of your choice.

  • Heavy-gauge tinned bow runs & dedicated windlass breakers
  • Watertight deck foot switches, helm rockers & wireless remotes
  • Gypsy, clutch, reversing solenoid & gearbox repairs
  • Fiberglass backing & deck hole glassing when upgrading models
Frequently Asked Questions

Common Questions Before You Schedule

A loud click usually means control power is reaching the reversing solenoid, but heavy current is not reaching or turning the motor—due to corroded solenoid contacts, weak batteries, high-resistance bow cable splices, or seized motor brushes/gearbox.
Pulling the boat forward with the windlass instead of bumping the engines forward overloads the motor. Other causes include a binding gypsy, corroded cables causing voltage drop (which spikes amperage), or a fatigued breaker.
Yes. We assess anchor-locker depth/fall, fabricate or install structural backing plates, cut and seal the deck cleanly, match chain/rope to the gypsy, and run heavy-gauge tinned wiring from the battery bank.
Yes—we repair and wire drum anchor winches, vertical capstans, and horizontal windlasses across center consoles, cruisers, and sailboats.
Get Started

Tell Us About Your Boat. We’ll Handle the Rest.

Send your vessel details here, or call or text photos directly to (904) 815-8421 for the quickest turnaround.

Call or Text Photos

(904) 815-8421 — call or SMS

Hours

8:00 AM – 6:00 PM, 7 Days a Week

Mobile Florida Coverage & Haul-Outs

Fully mobile — St. Augustine, Ponte Vedra (Marsh Landing), Jacksonville (Harbortown & Queens Harbour), Palm Coast, Fernandina to Daytona & anywhere in Florida · Haul-outs at Camachee Yacht Yard

Request a Free Marine Quote

Tell us your boat size, where it sits in Florida, and what you need. No obligation.

Optional — Fastest Estimate: After submitting, or right now, text 2–3 photos of your hull, cockpit, or equipment to (904) 815-8421.
Call Text Photos Free Quote