Factory-Clean Garmin & Navigation Retrofits Without Leaving Ugly Cutouts Behind
Upgrading older chartplotters to modern twin Garmin MFDs, adding open-array radar or FLIR thermal vision for early-morning St. Augustine Inlet runs, or dialing in a high-chirp sonar transducer requires more than bolting screens to fiberglass. You need clean NMEA 2000 backbones, interference-free wiring, waterproof cable glands, and dash panels that look factory-built.
Seacoast Detailing & Marine Services handles the entire helm upgrade from start to finish—including custom black acrylic dash panels, fiberglass/gelcoat hole closures, hardtop radar/lightbar rigging, and clean AV/KVH cabinet wiring.
Electronics & Helm Upgrades We Install
Garmin Chartplotters & Twin-MFD Suites
Flush-mount and pod installations, custom black acrylic dash fabrication, and clean Ethernet/NMEA 2000 networking.
Marine Radar, FLIR & LED Light Bars
Hardtop mounting, wedges, waterproof Scanstrut-style deck seals, and heading-sensor calibration for radar overlay.
Transducers & Dual Sonar Setup
Transom-mount and haul-out thru-hull transducer installations tuned for bottom structure off St. Augustine.
VHF Radios, AIS & Antennas
Clean coax routing, stainless ratchet mounts, GPS/NMEA 2000 DSC integration, and hailers.
Marine Audio, Amps & AV Cabinets
Marine head units, amplifiers, subwoofers, and organized AV/KVH equipment rack wiring.
Circuit Board & Existing System Troubleshooting
Diagnosing dead screens, NMEA network dropouts, sonar interference, and blown inline fuses.
From Center Console Helms to Sportfisher Bridges
Check our project gallery to see real local installs—from twin Garmin helm pods and dual sonar screens to hardtop radar/FLIR arrays and organized KVH/Tripp-Lite AV cabinets. Because we also do fiberglass/gelcoat repair and teak varnishing, we can close old dash cutouts or refresh a teak helm pod at the same time.
Text a photo of your current console or hardtop to (904) 815-8421 along with the electronics you want to install or troubleshoot.
Need multiple trades knocked out in one visit? Pair this service with fiberglass & gelcoat restoration, engine service, 12V marine electrical, Garmin installs, or Monthly Care Plans—or schedule during your haul-out at Camachee Yacht Yard in St. Augustine or the Florida boatyard of your choice.
- Garmin MFDs, radar, FLIR, transducers, VHF & NMEA 2000
- Custom black acrylic dash panels & clean old-cutout retrofits
- Available dockside, on lift/trailer, or during boatyard haul-out
- Clean wiring, labeled breakers & proper waterproof deck seals